Hey folks i just went back to use my iGPU to crunsh for seti, sofar so good.

Then i thought, is that all ? I mean always said you can`t overlock a Celeron G1820 cpu, but what´s about graphics ?

So i overclocked easaly my graphcis core +150 Mhz , temps at 50°C.

You could do that too, but it´s always dangerous to you cpu, i just want to remind you about this before.

https://downloadcenter.intel.com/de/download/24075/Intel-Extreme-Tuning-Utility-Intel-XTU-

It´s from Intel and easy to use, cross your fingers if u clock. D

---

With Intel's APU devices always worth to check total device throughput, not just GPU or CPU parts. The reason - they very strongly interrelated. Crunching on iGPU can decrease CPU part output in big degree. And vice versa.
So, check your device output being CPU-nly, then with iGPU enabled (and/or overclocked). Quite possibly best throughput will be achieved for smth between idle CPU cores and full-loaded cores+iGPU...

---

SETI apps news
We're not gonna fight them. We're gonna transcend them.

ok, i will post the results later, hope there is a minimum of 10% gain.

---

As i see, my i5-Ivy Bridge cpu can´t be clocked, dam...

---

ok, i raised to 1,250 Mhz , also applied Lunarics for cuda5.0 (broken GT640).

I´ll hate to waste time.

---

http://setiathome.berkeley.edu/result.php?resultid=5049777045

ok, 2hours 6minutes (clocked with 1250Mhz), too much for a improovment ?

don´t tell me i have run at stock too see a result, it´s late today.

---

5,000 seconds for ewhat ? 54 points naw not anymore, i´ll close all intelgpu workunits.

---

Is there any project (active) that have short worthy nice plesant workunits to crunsh ? First of all i search on WCG.

---

Nothing found on WCG, but on Collatz , slow on crunching but points.

---

3 days running, no issues only when i overlocked too much...clocked at 1250Mhz.

---