4.32 completed workunit problem


Advanced search

Message boards : Number crunching : 4.32 completed workunit problem
Message board moderation

To post messages, you must log in.

AuthorMessage
Adrien Seldon
Volunteer tester

Send message
Joined: 3 Apr 99
Posts: 12
Credit: 656,515
RAC: 0
United States
Message 101313 - Posted: 19 Apr 2005, 18:30:23 UTC

I recently upgraded to 4.32 (I know it is a development version, I am just reporting a bug). Everything was working fine until I completed my first unit on the new core client. The problem is that when a workunit is complete it goes to "ready to report" but does not start another unit until I manualy update the project, or presumably when the project automaticaly updates itself. When I ran 4.30 this did not happen. Since these units were partially completed when I upgraded I will continue to watch the machines and see if the problem repeats itself. I also posted this in the "Question and Problems" section.

Computers:

Laptop:
HP Pavilion zv5160us
P4 2.8
512 ram
Win Xp

Desktop:
P4 3.2 (hyperthreading enabled)
1024 ram
Win xp
ID: 101313 · Report as offensive
Profile Mike Special Project $75 donor
Volunteer tester
Avatar

Send message
Joined: 17 Feb 01
Posts: 34258
Credit: 79,922,639
RAC: 80
Germany
Message 101642 - Posted: 20 Apr 2005, 7:21:58 UTC

Hi

This is allready reported to bug report so far as i know.
This is not 4.32 special.

greetz Mike


With each crime and every kindness we birth our future.
ID: 101642 · Report as offensive

Message boards : Number crunching : 4.32 completed workunit problem


 
©2024 University of California
 
SETI@home and Astropulse are funded by grants from the National Science Foundation, NASA, and donations from SETI@home volunteers. AstroPulse is funded in part by the NSF through grant AST-0307956.